Transmission

JK Brake Pads. These TeraFlex JK: Front Big Brake Pads are a direct replacement for the pads in our Front Big Brake Kits for the JK Wrangler/Unlimited.

Référence : 53-JS-6036

E-Brake Cable.

Référence : 53-JS-6038

JL Hard Top Handles. Ease the removal and installation of your Jeep’s hard top with this Hard Top Handle Kit. Rubber bumpers protect the underside during storage.

Référence : 53-JS-6048

JK CV Yoke – Dana 60. TeraFlex JK: High-Angle Rzeppa CV Yokes are required for our High-Angle Rzeppa CV Driveshaft conversions. Includes dust shield.

Référence : 53-JS-6016

TJ Drag Link End. These heavy duty TeraFlex TJ: Drag Link Ends utilize a Dodge Dana 60 joint end, while the stock taper end fits the stock Jeep Dana 30 or Rubicon Dana 44 front axle.

Référence : 53-JS-6057

JK Axle Bracket.

Référence : 53-JS-6024

E-Brake Cable.

Référence : 53-JS-6042

JK Alpha Hole Caps. The TeraFlex JK: Alpha Spare Tire Carrier Hole Cap Kit blocks off the unused threaded holes on the Alpha HD Hinged Spare Tire Carrier when not using the accessory Alpha Hi-Lift Jack Mount.

Référence : 53-JS-6071

24" Control Arm Tube.

Référence : 53-JS-6032

JK Axle Bracket.

Référence : 53-JS-6022

JT Spring Spacer. Use these TeraFlex Coil Spring Spacers to level out a loaded vehicle. Compatible with stock height or lifted vehicles. Can be combined and/or stacked. Sold individually.

Référence : 53-JS-6012

JK Dana 60 Mount . TeraFlex JK: Tera60 Front Axle Brackets ensure correct suspension geometry on a Dana 60 style front axle housing with 3.25” diameter axle tubes.

Référence : 53-JS-6082

JK Upper Bracket. This simple JK: Upper Stud Frame Bracket attaches to the JK Wrangler/Unlimited frame and allows you to attach your sway bar link up out of the way when the sway bar is disconnected.

Référence : 53-JS-6066

TJ Long Arm Bracket. On higher lifts, our TJ: Pro LCG Long Arm Frame Brackets reposition the frame-end control arm mounting points to restore near factory orientation to reduce bushing stress during droop and shock load transferred through the control arms.

Référence : 53-JS-6088

YJ E-Brake Cable. This TeraFlex 1991-95 YJ: Emergency Brake Cable fits 1991-1995 YJ Wrangler (left) rear disc brakes – does NOT fit stock drum brakes.

Référence : 53-JS-6040

JK Front Axle Mount. TeraFlex JK: Tera60 Front Axle Brackets ensure correct suspension geometry on a Dana 60 style front axle housing with 3.25” diameter axle tubes.

Référence : 53-JS-6075

TJ Output Yoke. This replacement TJ / YJ / XJ: Rear Output Yoke fits the tail shaft of our TeraFlex NP231 Short Shaft Kits (TJ / YJ / XJ: # 4444401 or XJ Cherokee: # 4444402).

Référence : 53-JS-6017

TJ Tie Rod End. These heavy duty TeraFlex TJ: Tie Rod Ends utilize a Dodge Dana 60 joint end, while the offset stock taper end fits the stock Jeep Dana 30 or Rubicon Dana 44 front axle.

Référence : 53-JS-6058

JK Yoke – F or R. TeraFlex JK: High-Angle Rzeppa CV Yokes are required for our High-Angle Rzeppa CV Driveshaft conversions. Includes dust shield.

Référence : 53-JS-6013

JK Tera44 Bearings. The TeraFlex JK: Tera44 Master Bearing Install Kit includes all the necessary components to install a standard Dana 44 locker inside a TeraFlex JK: Tera44 Front Axle Housing. Features standard Dana 44 side carrier bearings.

Référence : 53-JS-6018

Speed Sensor. This Transfer Case Electronic Speed Sensor works in conjunction with the low-profile tone ring on our TeraFlex TJ: NP231 Extreme Short Shaft Kit (# 4444400) to deliver accurate and dependable speed signals to electronic instrument clusters.

Référence : 53-JS-6063

TJ Torque Shaft Rod. Use this 1997-2002 TJ SWB: Adjustable Transfer Case Torque Shaft Rod with the Transfer Case Shift Linkage Adapter Kit (# 4947100) when a longer torque shaft is required to mount between the linkage adapter kit and the transfer case lever.

Référence : 53-JS-6084

JK Axle Bracket.

Référence : 53-JS-6019