Kits Crown Jeep

Includes Manifold w/ Heat Shield, Gasket, Studs, EGR Block-Off Plate and Gasket.

Référence : 51-JS-6008

Année(s) : 87-02

Includes Clutch Disc, Pressure Plate and Throwout Bearing; 10-1/2″ Disc; 10 Splines; 1.125″ Spline Diameter.

Référence : 51-JS-6237

Référence : 51-JS-6183

NV3500/NV3550 Transmission Master Overhaul Kit; Includes Bearings, Seals, Springs, Snap Rings and Blocking Rings; With 33mm ID Countershaft Bearings.

Référence : 51-JS-6351

Crown Automotive's Steering kits are an affordable way to eliminate looseness in your old OE, worn out steering linkage. Included in each kit are all the tie rod ends, adjusters, and hardware necessary to mount the kit, as well as a steering stabilizer. All of our steering components are engineered to exactly match the factory design so It'll be guaranteed to bolt in place of the OE steering without any hang ups. Each kit is backed by a 12 month warranty.

Référence : 51-JS-6294

Référence : 51-JS-6105

Includes Clutch Disc, Pressure Plate, Clutch Control Unit, Pilot Bearing, Clutch Fork and Alignment Tool; 10.5″ Disc; 10 Splines; 1.125″ Spline Diameter.

Référence : 51-JS-6247

Référence : 51-JS-5998

Includes Oil Pan and Oil Pan Gasket.

Référence : 51-JS-6036

Tie Rod Assembly; Left Knuckle To Drag Link; Includes 2 Tie Rod Ends and Adjuster w/ Hardware.

Référence : 51-JS-6393

Rear Right; Kit Includes Axle Shaft (31-9/16″), Hub, Bearing, Key, Seal, Wheel Bolts, Axle Nut and Axle Washer.

Référence : 51-JS-6179

Année(s) : 82-86

Référence : 51-JS-6095

Dana 30 Pinion Bearing Kit; Includes Inner & Outer Pinion Bearing & Cup, Pinion Shims, Pinion Slinger, Pinion Seal and Pinion Nut.

Référence : 51-JS-6199

Référence : 51-JS-6080

Année(s) : 02-04

Front Wheel Bearing Kit; Includes 1 Inner and 1 Outer Bearing & Race and 1 Seal; 2 Required Per Vehicle.

Référence : 51-JS-6166

Référence : 51-JS-6269

Kit Includes 2 Engine Mounts, 1 Transmission Mount, 1 Insulator, 1 Snubber and 1 Bolt.

Référence : 51-JS-6034

Includes Progressive Coupling, Seals and Chain.

Référence : 51-JS-6305

Référence : 51-JS-6144

RT Off-Road's Performance Axles are a direct replacement for the factory shaft but are upgraded to a 4340 alloy steel. This alloy is heat treated to improve both tensile and torsional strength by 30%. The shaft splines are rolled, not cut, into the shaft to further increase overall component strength. Sold in pairs and includes hardware.Chromoly Axle Shaft Set; Includes 2 Axles, Bearings, Seals, Wheel Studs, Tone Rings and Retainers.

Référence : 51-JS-6174

Référence : 51-JS-6072

Référence : 51-JS-6381

Référence : 51-JS-6077