Kits Crown Jeep

Kit Includes Front Pipe, Midpipe, Muffler, Tailpipe and 2 Clamps.

Référence : 51-JS-6209

Référence : 51-JS-6111

Dana 35 U-Bolt Yoke Kit; 26 Splines.

Référence : 51-JS-6010

Torx Screw For Windshield Frame; Contains 16 Torx Screws.

Référence : 51-JS-6100

10 Spline Disc; 9″ Disc; 1.125″ Spline Diameter.Includes Clutch Disc, Pressure Plate, Clutch Release Bearing, Pilot Bearing and Clutch Alignment Tool.

Référence : 51-JS-6225

Référence : 51-JS-6082

1st & 2nd Gear Synchronizer Repair Kit; Includes 3 Synchronizer Keys and 2 Springs.

Référence : 51-JS-6056

Référence : 51-JS-6093

Référence : 51-JS-6094

Shift Linkate Repair Kit; Includes Bearing, Bushings, Seal and Hardware.

Référence : 51-JS-6309

Front Wheel Bearing Kit; Includes 2 Bearings, 2 Cups and 3 Seals.

Référence : 51-JS-6071

Axle Shaft Bearing and Seal Kit; Includes 1 Axle Bearing, 1 Axle Seal and 1 Axle Shaft C-Clip.

Référence : 51-JS-6192

Référence : 51-JS-6144

5th Gear Kit; Incliudes 5th Gear Counter and Mainshaft 5th Gear.

Référence : 51-JS-6062

Includes Pinion and Differential Bearings, Crush Sleeve, Oil Seals, Cover Gasket, Axle Seals and Axle Bearings; No Shims.

Référence : 51-JS-6190

Kit includes 6 Gears and 6 O-Rings; Various Ratios; Short Shaft.

Référence : 51-JS-6306

Includes Upper & Lower Grille Mount Bushings, Grille Mount Retainer, Grille Mount Washer, Upper and Lower Body Mount Bushings and Body Mount Retainers.

Référence : 51-JS-6078

Heavy duty solid steel construction; No modifications needed to factory mounting components; Right hand drive models only; Includes all hardware needed for installation; Steering stabilizer not included.

Référence : 51-JS-6285

RT Off-Road's Performance Axles are a direct replacement for the factory shaft but are upgraded to a 4340 alloy steel. This alloy is heat treated to improve both tensile and torsional strength by 30%. The shaft splines are rolled, not cut, into the shaft to further increase overall component strength. Sold in pairs and includes hardware.Chromoly Axle Shaft Set; Includes 2 Axles, Bearings, Seals, Wheel Studs, Tone Rings and Retainers; 27 Splines; Same as Factory Shafts.

Référence : 51-JS-6067

Référence : 51-JS-6193

Includes Clutch Disc, Pressure Plate, Clutch Control Unit, Pilot Bearing, Clutch Fork and Alignment Tool; 10.5″ Disc; 10 Splines; 1.125″ Spline Diameter.

Référence : 51-JS-6247

Tie Rod Assembly; Knuckle To Knuckle; 40-1/2″ Long; Includes Tie Rod Ends, Tube and Clamps.

Référence : 51-JS-6296

Référence : 51-JS-6348